Features: Made of forged steel, this hydraulic puller is very strong and durable, with good bearing capacity and long service life. Itis equipped with 3 pulling claws, which can be adjusted from high to low, and can be pulled with two or three legs according to different needs. There is a handle that can be opened, which can be operated with very little operation and get great pulling force. The safety overflow valve control switch on the pump body is ready to avoid oil pressure overload. Thehydraulic puller adopts the design of 360-degree pump head, which is easy to operate and easy to use. After rotation, it can quickly contact the working center according to the distance between the puller and the position center. Suitable for traction hubs, flanges, gears and bearings, with a maximum carrying capacity of 10 tons. Specification: Material: carbon steel + cast iron Ares travel: 2 inches (50 mm) Maximum capacity: 5T Minimum/maximum range: 0"-5.51"(0-140mm) Minimum/maximum transmission: 4- 7.87"(100-200mm) Weight: Approx.7100g/250.4oz Usage and precautions: 1. Please put the open handle end into the puller shaft and tighten the shaft according to the clock direction. 2. Adjust the jaws to maintain proper distance and Angle from the pulling position. 3. Rotate the handle to make the piston shaft move, and promote the power of the jaw to disengage the object. 4.The maximum stroke of this hydraulic puller is 50mm, please pay attention when using it, so you may need to try many times when the object is still in the position that meets the requirements of the stroke. 5. To return the piston starting rod, simply use the grooved end of the handle and rotate the return stem counterclockwise. 6.Don't overload. 7. Use (GB443-84) oil N15 at -5~ 45, the spindle oil (GB442-64) synthesis in-20~-5. 8. The machine uses oil as the medium, so the oil and the machine must be kept together. 9.With a new setting or a long setting, the hydraulic puller can be loaded 2 to 3 times to eliminate the air cavity since there is a large amount of air in the cylinder and the rod may have a small sudden jump when starting. Although the gear puller is out of use for a long time, you should reciprocate the gear puller 2-3 times a month. Package list: 1 x Hydraulic Puller 1 x Handle 1 x 2/3 Leg Puller Yoke 3 x Jaws 6 x Nuts and Bolts 6 x Link Plates 1 x Nose Adapter 1 x Carrying Case Note:Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering..